Help; Behringer air besturen via exteren wifi router

[Da Vinci]

Wat jij wilt moet kunnen, volgens de handleiding pagina 12, 13 en 14.
Die twee apparaten (mixer en router) moeten elkaar via een kabel kunnen herkennen en verstaan.
Gewoon niet opgeven, dan gaat het je lukken!

edit: zie ook deze discussie op het X-Air forum.

Ja dit had ik ook al gelezen. Van pagina 14: "While being connected in Ethernet mode, the X AIR mixer can
scan the available wireless networks and display their SSID network names,
field strength and security method. By selecting the preferred wireless network,
this information can be copied to the applications' Wifi Client setup page
automatically. You will then be prompted to fill in the security password of that
network. "

JA MAAR HOE DAN?


Ah... de link...

- Make sure your computer and external router are setup properly in order to accept DHCP for automatic IP addressing or STATIC for manual input of IP address, subnet mask and gateway.
- Set REMOTE switch on the front of the XR18 to ETHERNET
- Open X AIR EDIT App and check the SETUP/LAN tab has the LAN-MODE set to DHCP for automatic IP addressing (or STATIC for manual input of the IP Address, Subnet Mask and Gateway of your router. To make changes between STATIC, DHCP or DHCP SERVER you must connect directly to the XR18 via ACCESS POINT or ETHERNET. (See options #5 and #6 below)
- Connect Ethernet cable from ETHERNET PORT on the XR18 to your External Router, set REMOTE switch on the front of mixer to ETHERNET.
- Connect 2nd Ethernet Cable from your computer to your External Router
- In the X AIR EDIT App, after your computer establishes a connection to the External Router's Network, you will see the mixer pop up in the SETUP/CONNECT tab.

Nou... dat ga ik eens proberen!