Ik ben me in aan het lezen om de rotte PCB van mijn JMP 2203 te vervangen door een PtP bord en toen kwam ik dit tegen:

TECH NOTE: The violet wire is referred to as the “negative feedback” wire. It’s purpose is to feed a small part of the amplifier output back into the circuit. This serves to stabilize the circuit and contributes to the characteristic Marshall tone. It’s important to note the appropriate terminal to wire your NF to according to your output tube type:
• EL34’S should be wired to the 8Ω switch terminal (as shown above)
• 6550’s, KT88’s and 6L6’s should wired to the 4Ω switch terminal
Bron: http://www.metroamp.com/downloads/10...T_DOWNLOAD.pdf -> Stap 19


Moet ik bij mijn 1987x ook de NF (paars) aan 4 Ohm (geel) bevestigen ipv 8 Ohm (groen)? Welk effect kan ik verwachten?