Citaat Oorspronkelijk geplaatst door boss
Uit de manual van de GCX:

Using the GCX without a Ground Control
__________________________________________________ _______
Warning: The PEDAL IN jack on the GCX is not a standard MIDI In. It utilizes the two normally unused pins to provide 9 volts A.C. power for the Ground Control. Before connecting to a device other than the Ground Control, you must either use a cable without pins 1 and 3 wired, or verify that the MIDI Out of that device conforms to the MIDI specification which states that pins 1 and 3 are unconnected. Failure to do so can result in severe damage to your equipment. If you have any questions about this, please contact Digital Music Corporation's customer service department.

It is possible to control the GCX from other devices like MIDI sequencers, some MIDI footpedals, or any device capable of transmitting MIDI Control Change messages.
The GCX responds to MIDI Control Change messages sent on channel 16 only. A data value of 0 turns the loop off, a data value of 127 turns the loop on.

Controller numbers are as follows:
Audio Loop or Latched Switch
Loop #1 = controller #80
Loop #2 = controller #81
Loop #3 = controller #82
Loop #4 = controller #83
Loop #5 = controller #84
Loop #6 = controller #85
Loop #7 = controller #86
Loop #8 = controller #87

Momentary Switch
Loop #1 = controller #104
Loop #2 = controller #105
Loop #3 = controller #106
Loop #4 = controller #107
Loop #5 = controller #108
Loop #6 = controller #109
Loop #7 = controller #110
Loop #8 = controller #111
deze manual heb ik ook gelezen... ;-)
uit dit stukje blijkt volgens mij ook wat ik zeg; om je loops in een preset "mee" te schakelen moet je met de preset dus 8 cc's kunnen meezenden, toch? als ik het goed lees???
en dat kan de big foot dus niet volgens mij, althans ik kan het niet vinden in de manual.