Van een John Frusciante-forum:


Refer to the attached sketch. Solder the 2 original leads from the spdt switch to one pole of the new 3pdt switch. De-solder appropriate lead as shown from input and output resistors. Solder new leads to free end of resistors and to two holes the resistor ends used to occupy. Complete wiring as shown. Test the unit before stuffing everything back into the housing. Remove all the foam pads to maximize stroke. I notice a slight reduction in stroke but not enough to miss. I may grind out the pad that hits the switch to get even more stroke out of it.



Lijkt me niet al te moeilijk.